Dental Research Today is a free monthly online journal that collates and summarizes the latest research about Dental, including details on implants, health, hygiene, cosmetic, dentistry.

Surface integrity and removal mechanism in simulated dental finishing of a feldspathic porcelain.

Yin L, Song XF, Qu SF, Han YG, Wang H

School of Mechanical Engineering, Tianjin University, Tianjin 300072, China. lingyin@tju.edu.cn

Dental abrasive finishing of a fine-grained feldspathic porcelain was performed on a computer-assisted apparatus for simulation of a 2-degrees-of-freedom restorative operation with a dental handpiece and a coarse diamond bur of grit size of 106-125 mum. Finishing forces, surface roughness, and morphology were investigated as functions of finishing conditions. The tangential and normal forces were measured using a piezoelectric dynamometer and a data processing system. The results indicated that these forces increased with either the depth of cut or with the feed rate, in the ranges of 0.12-0.31 N and 0.45-1.09 N, respectively. However, an increase in either depth of cut or feed rate affected neither the surface roughness measured using a stylus profilometer nor the morphology observed under a scanning electron microscope. The finished porcelain surfaces were found to consist of the microfracture and chipping areas, ductile removal areas, smeared areas, and debris. Irregular fracture and chipping resulted from the extension of lateral/median cracks; ductile micromachining was attributed to the plastic deformation accompanied by distributed microcracks. It was determined that a combination of the microfracture and ductile micromachining was the primary mechanism for material removal.

Published 12 October 2006 in J Biomed Mater Res B Appl Biomater, 79(2): 365-78.
Full-text of this article is available online (may require subscription).

© 2004-2008 Dental Research Today. All Rights Reserved.